Vibration trigger: mounting and tuning

Hello!

Ask me any question about Lympik.

Please be as specific as possible so I can help you better.

Answers are AI-generated and may be inaccurate!

A rider jumping onto a feature makes a sharp impact, and sliding along it then keeps the feature vibrating. The Soundbox only plays when both happen. A snowball, a shovel or a hand slap causes a short knock that dies out quickly, so it doesn't count. Wind and snow load build up too slowly to count.

Mounting

  • Bolt the box firmly to the feature (rail, box, jib), ideally at the entry end where riders jump on. A loose mount damps the vibration and gives poor detection.
  • After switching on, keep the feature still for a few seconds while the box learns the normal background vibration. It can trigger after about 3 seconds and is fully settled after about 10 seconds.

Settings

Open setup mode and go to Advanced → Vibration trigger:

  • Sensitivity (1–10, default 3): 1 is the least sensitive, 10 the most sensitive.
  • Hold time (0–2000 ms, default 50 ms): how long the vibration must last after the impact before the sound plays. 0 plays on the impact alone.
  • Status: "detected" with the current vibration level, the threshold and the number of triggers (fires), or NOT DETECTED.
Vibration trigger settings with sensitivity 3, hold time 50 ms and status detected

Tap Save configuration to save your changes. They take effect when the box restarts.

Tuning on site

  • Rider hits are missed: raise the sensitivity by 1–2, or lower the hold time.
  • Plays on knocks, snowballs or people walking past: lower the sensitivity, or raise the hold time (e.g. 150–300 ms).
  • Plays twice for one rider: raise the dead time (see Triggers, sound and sleep mode).
  • Sound starts too late: lower the hold time.

Change one setting at a time and test with a few real hits. The fires count in the status line tells you how often the sensor triggered.

Good to know

  • The box does not react to its own sound: the sensor is muted while a sound plays and for 2.5 seconds after it ends. This can't be changed.
  • Status NOT DETECTED means the sensor isn't working. The wired inputs still work. Please contact your dealer.
  • To use wired sensors only, untick Vibration (IMU) under Trigger sources.