SOUNDBOX 2026 troubleshooting

Hello!

Ask me any question about Lympik.

Please be as specific as possible so I can help you better.

Answers are AI-generated and may be inaccurate!

Before you start troubleshooting, switch on the Soundbox or restart it by unplugging the battery connector and switching the Soundbox on again.

Soundbox with its numbered parts

The device does not start

Check the battery (2) and connect a different one if necessary. If the status LED (6) stays red after start-up, press the power button once to restart. If it is still red, please contact your dealer.

There is no sound

  • The status LED stays dark when triggered: check whether sleep mode is active (times are in UTC), whether setup mode is still open (blue LED), whether the input is ticked under Sources, and whether the last sound played less than 3 seconds ago (dead time).
  • The status LED flashes red when triggered: there are no playable sounds on the box. Upload sounds with a lowercase .mp3 ending, see Sounds: upload and manage files.
  • The status LED flashes green, but you hear nothing: check the volume (below about 60 it is very quiet) and the speaker (3). Test with ▶ next to the volume slider.

The vibration trigger misses riders or plays too often

Missed hits, sounds on knocks or two sounds for one rider: see Tuning on site in Vibration trigger: mounting and tuning.

Light codes at power-on

  • Magenta, 3 quick blinks: the vibration sensor was not found. The wired inputs still work. Please contact your dealer.
  • Yellow, 5 quick blinks: the clock lost its time. Open setup mode once to set it again.

Read the error code

Open setup mode and go to Advanced. The trigger counter (Code) and the last error (Error reason) are shown at the top of the page.